AGUASTOP, WATERPROOFING PUTTY, 300 ML CARTRIDGE, GRAY COLOR, CEYS

CHARACTERISTICS

Applicable wet, even under water

· Great multi-material adherence

Does not drip or hang

High resistance to weathering and UV rays

Resists standing water

· Without loss (without water or solvents)

Adheres to AguaStop Total Barrier

APPLICATIONS

Repair of cracks and fissures in singular points of the roof

Repair of damages that cause water ingress

Repair and sealing of pipes, gutters, downspouts and drains.

Joints in chimneys, skylights and ventilation outlets

Protection of vertical anchors (lightning rods, satellite dishes, lighting)

Punctual repair of asphalt cloth self-protected with aluminum (in good general condition)

HOW TO USE

Support preparation:

Completely remove dirt, dust, grease, oil, remains of previous paint, salt efflorescence, fungi, algae and any element or substance that prevents the adherence of AGUA STOP REPARADOR TOTAL to the support.

General application of the product:

Apply with a spatula, trowel or brush on the surface (ideally dry, although it can be applied on damp supports). Always apply a thickness of a minimum of 3 mm of product. Pay special attention when applying with a roller; the necessary thickness must be ensured to give adequate protection to the support. A performance lower than the recommended one would produce the premature degradation of the membrane, minimum 3mm thick.

Tip and precautions:

· If it is applied in two coats, apply the second coat after 7 hours and no more than 24 hours.

· The temperature of the support and the product at the time of application must be between +5ºC and +25ºC.

· Immediately clean application tools and splashes with solvent. Once dry, the product can only be removed by mechanical means.

· Once opened, it is recommended to cover the product in its surface with plastic so that there is no air left when closing the container and cause it to dry in the container.