TEE, CENTER REDUCED, D-28 / 15 / 28mm, POLYBUTYLENE FITTING.

T, DERIVATION, REDUCED TO THE CENTER, D-28 / 15 / 28mm, ACCESSORY FOR POLYBUTYLENE.

Accessory for Polybutylene Pipe, (Pb), according to Standard, UNE EN ISO 15876, certified by AENOR for pipe and system.

Standards included in the CTE.

Valid for cold water and hot water installations, SERIES 4 for DN 15 and SERIES 5 for 16, 22, 25 and 28mm.

NOTE: THE ACCESSORY DOES NOT HAVE A BUILT-IN BUSHING.

Do not loosen or disassemble the accessory to install, it is installed as it comes from the factory.

Insert the bushing into the pipe before inserting it into the accessory.

Avoid scratches on the section of pipe that enters the accessory.